A serpentine belt is a crucial a part of any engine. The serpentine belt is so-referred to as as a result of it usually runs a number of equipment and “snakes” round beneath the hood. On a Chevy Silverado, the serpentine belt drives the alternator and different features of the car: Typically, the V6 type may have one serpentine belt for all parts, whereas the V8 could have a separate belt for the air conditioner compressor.
Chevy Silverado Replace the Serpentine Belt Instructions
Discover the auto-adjusting belt tensioner pulley. The belt tensioner might be situated utilizing a belt routing diagram, which you must discover on the radiator assist. Use your wrench or breaker bar to rotate the bolt on the belt tensioner to launch pressure on the belt.
Slip the previous serpentine belt off of the pulleys and take it out.
Use the belt routing diagram once more to route the new belt. If you cannot discover a routing diagram in your documentation, or below the hood, you need to use the Dayco product website the place belt routing diagrams are in hyperlinks subsequent to the belt description. Enter make, type and yr to get the proper routing diagram.
Rotate the belt tensioner once more to permit the belt to be absolutely put in. Be sure the belt is nicely seated on all of the pulleys. Run the engine and observe to verify the belt is put in correctly.
[source ehow.com]
